Average Speed

Vehicles & plant Fully automatic

Site speed limits, measured rather than hoped for.

Speed limits on site roads only work if someone measures them. The Average Speed agent times vehicles between two points on haul roads and access routes, checks them against the posted limit and reports speeding by vehicle and contractor, with an audit trail for your traffic management plan.

Average Speed on a live site

Average Speed agent

Measures vehicle speed between two points on site roads and haul routes.

Trusted on live sites

Scopis runs on active construction sites, automotive sites and utility infrastructure.

Offices in Dublin and Hong Kong

What it does

What the Average Speed agent does on your site

  • Posted limits checked automatically
  • Speeding reports by vehicle and contractor
  • Audit trail for compliance
ConstructionLogistics
How it works

Live in four steps

  1. 01

    Connect

    Existing ONVIF cameras, or solar 4G units where there is no power or network.

  2. 02

    Configure

    Draw the zones, set the schedule and choose who gets which alert.

  3. 03

    Set the bar

    Choose how confident the agent must be before it acts on its own.

  4. 04

    Act and record

    Warning on site where it applies, alert with the clip, and an audit entry.

Questions

Average Speed: common questions

Does the Average Speed agent need new cameras?

No. It runs on existing ONVIF fixed and PTZ cameras. Where a site has no power, network or cameras, solar 4G units add coverage and report into the same platform.

Does someone have to watch the Average Speed alerts?

No. This agent runs fully automatically and sends results and alerts to the people you choose.

Where is the Average Speed agent used?

Typically on construction and logistics sites, alongside other Scopis agents on the same cameras.

See it on your site

See the Average Speed agent on your own cameras.

A 30-minute walkthrough on live deployments, then a pilot on one zone of your site before anything is committed.