Vehicle Permit

Vehicles & plant Fully automatic

Only permitted vehicles on site, checked automatically.

The Vehicle Permit agent checks every vehicle entering against the permits you have issued, flags any that should not be there and keeps an automatic access log. It removes the paper list from the gatehouse and gives you a clean record of who was on site and when.

Vehicle Permit on a live site

Vehicle Permit agent

Checks that every vehicle entering has a valid permit to be there.

Trusted on live sites

Scopis runs on active construction sites, automotive sites and utility infrastructure.

Offices in Dublin and Hong Kong

What it does

What the Vehicle Permit agent does on your site

  • Permit checked at the gate
  • Unauthorised vehicles flagged
  • Automatic access log
ConstructionIndustrial
How it works

Live in four steps

  1. 01

    Connect

    Existing ONVIF cameras, or solar 4G units where there is no power or network.

  2. 02

    Configure

    Draw the zones, set the schedule and choose who gets which alert.

  3. 03

    Set the bar

    Choose how confident the agent must be before it acts on its own.

  4. 04

    Act and record

    Warning on site where it applies, alert with the clip, and an audit entry.

Questions

Vehicle Permit: common questions

Does the Vehicle Permit agent need new cameras?

No. It runs on existing ONVIF fixed and PTZ cameras. Where a site has no power, network or cameras, solar 4G units add coverage and report into the same platform.

Does someone have to watch the Vehicle Permit alerts?

No. This agent runs fully automatically and sends results and alerts to the people you choose.

Where is the Vehicle Permit agent used?

Typically on construction and industrial sites, alongside other Scopis agents on the same cameras.

See it on your site

See the Vehicle Permit agent on your own cameras.

A 30-minute walkthrough on live deployments, then a pilot on one zone of your site before anything is committed.